"Note: The above ScreenLogic Interface Kits (520502) require a four-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter within the home. I was just hoping part of the kit I already had installed given my system already has the wireless pentair controller. My question was really around the wireless connection which they have an entire kit for (p/n 521964). I would also contact the manufacturer of your existing pool controller to see if third party integration is even a possibility with your current model to make sure your not on a wild goose chase This will then allow for a easy integration and also provide an app for further control.
My best advise is to install a verifiable pool controller that has a ip driver available. Still searching for some advice in this scenario. 221 Pentair ScreenLogic Mobile, 210 Reef Tank Pro, 210 Remote, 206 Roku, 207 Sonos Controller, 207 TiVo, 207 X10 Commander, 210 Arsenal indash audio. My sense is that others must have installed in some situations without a direct cable connection. There are several parts to buy or that you could buy so wanted to make sure i get it right. Quickly and easily setup circuits, pump speeds, etc. Pentair support for the consumer is worthless and they dock the warranty to 90 days if you don't have a certified tech install the thing-good luck finding one. Pentair sells an entire Wireless Package for its Screenlogic system but the wireless receiver looks identical to the one i already have installed. Convenient interface to configure local and remote Pentair Pool & Spa control systems that have ScreenLogic. Screenlogic wireless is a disaster itself. Control your pool and spa from a local Wi-Fi network, or control remotely. The other scenario that is less clear is using the existing Pentair wifi used for EZtouch remote to broadcast to a Pentair transceiver, then the transceiver integrates into the home network (or maybe even rs232). You can now also use our Alexa Skill to control your EasyTouch or IntelliTouch system. I think i have it understood for the scenario running a wire to the control unit. This allows homeowners the chance to make these upgrades.
I don't recall ever seeing a pentair EZ touch driver so that could also be a limiting factor. In this video, we walk you through how to connect the Pentair IntelliCenter to a wireless network. the middle two are data lines A and B (labeled yellow/green), and the remaining two are Power (red, 15vdc), and Ground (black). It also has to be a unit that allows for integration. Pentair systems have four terminals on the comm bus connectors. Pentair Screenlogic Interface & Wireless Connection Kit for EasyTouch & IntelliTouch Control Systems EC-522104 Use iPad, iPhone, iPod touch Mobile Digital. Every pool that I've integrated needed a wire to the controller to either provide a network connection or to use rs232.